| 1. | The torquing current is measured and related to drift rate by prior calibration data .
测出产生力矩的电流，然后根据事先校正的数据来算出飘移率。 |
| 2. | To promote the acceptance of test and calibration data from accredited laboratories , both locally and internationally
推动本地和国际机构接纳由认可实验所发出的测试及校正资料。 |
| 3. | Finally , the external and internal calibration methods and the processing of calibration data are studied
最后研究了低频uwb - sar外部校准和内部校准的方案设计,校准数据的处理等方法。 |
| 4. | Capability of detection - methodology for determination of the critical value for the response variable when no calibration data are used
检测能力.在无校准数据可采用情况下测定反应变量关键值的方法 |
| 5. | Capability of detection - part 3 : methodology for determination of the critical value for the response variable when no calibration data are used
检测能力.第3部分:在无校准数据可采用情况下测定反应变量关键值的方法 |
| 6. | Capability of detection - part 3 : methodology for determination of the critical value for the response variable when no calibration data are used
检测能力.第3部分:在无校准数据可采用情况下测定反应变量临界值的方法 |
| 7. | At last , 3d reconstruction is completed based on the calibration data . real image and synthetic data experiment results are presented in the end of each chapter
最后基于获得的标定数据完成三维重构并最终给出真实或者模拟的三维重构实验结果。 |
| 8. | 3 . the variation of the number of the principle components , shape , physical meaning and the explainablity with the change of calibration data and the sample complexity is systematically studied for the first time
首次系统研究了随着样品成份复杂性的变化以及光谱数据预处理方法和波长区域的不同，主成分的个数、意义及其可解释性的变化情况。 |
| 9. | Combining with the modem electronics and computer technology , the calibration data are processed . and then the calibration result is displayed and printed . so that to calibration efficiency is improved ; man - made error is eliminated ; the calibration accuracy is enhanced
论文采用专门开发的专用扭矩传感器，结合现代电子技术和计算机技术，将检定结果进行数据处理，然后显示并打印出检定结果，目的是提高检定速度，而且消除人为读数误差，提高检定准确度。 |
| 10. | Using the system designed in this thesis work , flow field calibration of the wind tunnel is accomplished , which covers dynamic pressure drop coefficient , dynamic pressure time stability , axial static pressure gradient , boundary layer , and degree of turbulence , etc . boundary layer measuring principle and method are especially described in detail , the relationship between boundary layer thickness , wind speed setting , and the depth of the experimental section is summarized , and finally the calibration data for th e model center zone under specific wind speed are given
然后利用本文设计的系统完成了落差系数、动压时间稳定姓、轴向静压梯度、边界层及湍流度等内容的流场校测。特别对边界层测量的原理及方法做了较详尽的叙述，总结出边界层厚度与设定风速、实验段深度的关系，然后给出模型中心区一定风速下校正数值。 |
